Step 01
Signs
• Dryer stops mid-cycle and displays tS error code
• Clothes are not drying properly or come out damp
• Dryer runs but does not reach normal operating temperature
• Error code appears intermittently during operation
• Dryer may not start or complete a full cycle
• Control panel may become unresponsive after error appears
Step 02
Possible Causes
• Faulty thermal sensor element in the dryer drum or heating chamber
• Loose or disconnected wiring harness to the temperature sensor
• Control board failure preventing sensor signal recognition
• Moisture or lint accumulation interfering with sensor function
• Defective temperature sensor connector or contact corrosion
• Power supply fluctuations affecting sensor circuit on 240V line
• Damaged thermal fuse or thermostat causing false error signal
• Software glitch in the dryer's electronic control system
Step 03
Safety Checks You Can Do
• Verify your home circuit breaker is in the ON position and has not tripped; reset if necessary
• Remove and clean the lint filter thoroughly, then check for lint buildup inside the filter housing
• Inspect the dryer vent opening outside your home and clean any blockages or lint accumulation
• Ensure the dryer door closes completely and latches securely with no obstructions
• Check that you have selected an appropriate drying cycle with correct heat settings on the control panel
• Allow the dryer to cool for 30 minutes, then attempt to run a new cycle
• Perform a hard reset: switch off the circuit breaker to the dryer for 60 seconds, then switch it back ON and attempt a test cycle
• Verify the dryer is receiving proper 240V power by checking if other indicators light up on the control panel
• Do not attempt to disassemble the dryer or access internal components; contact a licensed technician if error persists