Responsive Menu
Add more content here...
Menu Close

GE Dishwasher Error Code C5

The C5 error code indicates a wash motor failure or motor circuit malfunction on your GE dishwasher. This error prevents the dishwasher from completing its wash cycle and requires attention to restore normal operation.

Step 01

Signs

• Dishwasher stops mid-cycle and displays C5 error code • Wash arms do not rotate during the wash cycle • Water remains standing in the bottom of the tub • Unusual grinding or clicking sounds coming from beneath the tub • Dishwasher will not start a new cycle • Control panel lights may flicker or dim when error appears
Step 02

Possible Causes

• Wash motor has failed or burned out • Motor thermal overload switch has tripped due to overheating • Loose or corroded electrical connections to the motor • Faulty motor capacitor preventing motor startup • Clogged pump or debris blocking motor function • Defective motor control board or electronic control unit • Power supply issue specific to 120V North American electrical standards • Spray arm obstruction causing motor to stall and fault
Step 03

Safety Checks You Can Do

• Check your home's circuit breaker panel—locate the breaker for your dishwasher and verify it has not tripped; if tripped, reset it and attempt to run a cycle • Ensure the dishwasher door is fully closed and the latch engages completely with an audible click • Open the dishwasher and inspect both spray arms (upper and lower) for clogs, debris, or mineral buildup; rinse them thoroughly under running water • Check the filter basket at the bottom of the tub for food particles, broken glass, or foreign objects; remove and clean completely • Verify that dishes are not blocking the spray arms or preventing them from rotating freely • Review your dishwasher's control panel settings to ensure you selected the correct cycle and that no settings are preventing startup • Perform a full reset: Turn off the circuit breaker for your dishwasher for 60 seconds, then switch it back on and attempt to run a test cycle • Allow 5-10 minutes after a power fluctuation or outage before restarting the dishwasher to allow the control board to fully initialize • If the C5 error persists after these checks, contact a certified GE service technician as the motor or control board likely requires professional repair or replacement
Always disconnect power before performing any checks. If unsure, contact a certified technician.

Ready to Get Your GE Fixed?

Contact our local team today for fast, reliable service in your area.